FINISH FOR PARQUET RENNER RPXX60

Is a finish for wood floors, with excellent transparency and high resistance to abrasion by foot traffic. Formulated based on polyurethane resins, is extremely wear-resistant, elastic, with a reduced solvent content and free from substances of concern for the health of the user and for the environment. The special UV filters make it also non yellowing and allow a good protection of the natural colour of the wood.

The floor new. Sand raw wood with 150 grain sanding paper
and remove the dust. Apply 3 coats of RPxx60 at a distance of 2-4 hours. You do not need to sand between coats. For best performance, apply 1 coat of undercoat RP1060 and 2 coats of Finish RPxx60.
A varnished floor. The wood is already coated with finishing products in good condition, must be sand with grit 240-280. Clean the surface and proceed with the painting. The wood is already coated with finishing products in a bad condition, must be sand with grit 80-150 to bring the wood in the raw state. Clean the surface and proceed to paint as indicated for new wood.

Finish for parquet RPxx60.