CEBOART MARMORINO

Covering decorative for interior and exterior, based on the slaked lime is matured and filtered, which ensures in a natural way a perfect adhesion to the substrates, high breathability, resistance to mold and bacteria, stability and durability. CeboArt Marmorino allows you to produce finishes of the highest quality, creating on the surfaces of the satin effect and gently dotted the marmorino classic.

The preparation of the funds

Are suitable for all the funds to plaster, to whitewash, to civil. Verify that the supports are clean, dry and uniform in appearance, and in the absorption.

CeboFix R:

Pigmented fixative breathable, containing quartz flour. CeboFix R applies to the hand with a roller, short haired. Drying was CeboFix R, in the case of funds particularly rough or uneven, apply the skim coat lime based CeboFondo.

Application cycle CeboArt Marmorino

On the prepared base and completely dry, apply a first coat with stainless steel trowel: after drying, apply the second coat by compacting the product.

Application cycle CeboArt Lux on CeboArt Marmorino

On the prepared base, apply one coat of CeboArt Marmorino coloured, with trowel in stainless steel. Proceed in the application a small cross, whereas in this step determines the design of the decoration at the end; before it is completely dry, smooth the surface to eliminate any imperfections. On CeboArt Marmorino,
perfectly dry and free of dust, apply a first coat of CeboArt Lux colored in the same tint of CeboArt Plaster, with a trowel in stainless steel, progressing to spatulate cross and following the design previously created with CeboArt Plaster; when the product will dry on the surface (about 3-4 hours) apply the second coat of CeboArt Lux casting and removing the product to carry out a first polishing. Later, when the wall will begin to clear, and then to dry, go over the surface repeatedly to the surface with the stainless steel trowel clean to complete the polishing.

EcoCera:

Natural wax interior water-based beeswax and white marseille soap, water repellency and enhances the natural gloss of the surfaces. Carefully mix the product before application: if it is thick, dilute with 5% water hot. Apply EcoCera only after the complete drying of CeboArt Stucco or Marmorino. Apply the product with synthetic sponge, avoiding excessive loads of the product; where, within 30-40 minutes of polishing by hand with wool cloth.

Application cycle CeboArt Marmorino

CeboArt Marmorino is a ready-to-use, and is applied in two coats using a trowel stainless steel. Apply a first coat of the product to shave. Wait for the successful drying and, apply the second coat by compacting the product.