CEBOART LUX

Fine finishing for interiors, based on slaked lime and waxes natural. CeboArt Lux enriches the surfaces decorated with CeboArt Model, enhancing the depth of the drawing and giving it an exceptional shine.

Application:

Application cycle CeboArt Lux on CeboArt Model:

On CeboArt Model, perfectly dry and free of dust, apply a first coat of CeboArt Lux colorful, with trowel in stainless steel, taking care to follow the pattern previously created with the strokes. When the product will dry on the surface (about 3-4 hours), apply the second coat. It is recommended that, in both hands, apply a thin layer of the product. Later, when the wall begins to dry, wipe the surface with the trowel in stainless steel clean to complete the polishing.

Application cycle CeboArt Lux on CeboArt Marmorino:

On the prepared base, apply one coat of CeboArt Marmorino coloured, with trowel in stainless steel. Proceed in the application a small cross, whereas in this step determines the design of the decoration at the end; before it is completely dry, smooth the surface to eliminate any imperfections. On CeboArt Marmorino,
perfectly dry and free of dust, apply a first coat of CeboArt Lux colored in the same tint of CeboArt Plaster, with a trowel in stainless steel, progressing to spatulate cross and following the design previously created with CeboArt Plaster; when the product will dry on the surface (about 3-4 hours) apply the second coat of CeboArt Lux casting and removing the product to carry out a first polishing. Later, when the wall will begin to clear, and then to dry, go over the surface repeatedly to the surface with the stainless steel trowel clean to complete the polishing.