CEBOSI RIFLESSI ORO

Acrylic water for internal, machine, semicoprente. CeboSi Reflections allows you to create modern glazes which are characterized by reflections with metallic tones ofgold, that give brightness and elegance to every environment. In addition to the traditional application (the effect is smooth), it is possible to create modern designs in relief (effect , spatula, striped), choosing between the different cycles of the proposed applications. CeboSi Reflections can be further enhanced with the addition of CeboLux, a precious additive to mica-based natural and that gives the finish intense touches of light.

Preparation of the supports:

Check that the media be uniform, perfectly clean and dry. In the presence of shavings recent funds, peeling or absorbent to perform a perfect cleaning of the support and first apply the fixative insulating CeboFix M with a brush in one hand. The use of the fixative is especially recommended for the subsequent application of the CeboIdea.

Application cycle - smooth effect

Apply CeboSi the Bottom, colored in tint as the finish, with roller, short pile in one or two coats until complete coverage of the bottom. Wait for the successful drying. Apply CeboSi Reflections in one hand with the brush CeboSi, available in sizes from 2½ and 4 inches. Apply the product to the brush strokes in a crisscross, avoiding baseboards assets; continue the application until you reach the part machined with the tool exhaust, so as to avoid obvious overlaps of color. CeboSi Reflections can also be applied to the glove: dip the tool into the product and pass it on in circular motions and uniform, with a light hand, and as flat as possible.

Application cycle - and-effect finish

Apply CeboIdea, colored tint as the finishing trowel in stainless steel. Spread the product evenly over the surface, and then achieve the aesthetic effect presented by working with the trowel in irregular strokes. The complete drying of the CeboIdea lightly sand the surface to remove any imperfections. Apply CeboSi Reflections sponge in one hand. Spread the product on the surface with movements smooth and continuous, in order to avoid unaesthetic signs of recovery.

Application cycle - ribbed effect

Apply CeboIdea, colored tint as the finishing trowel in stainless steel in a uniform thickness of 1-2 mm. Work the product before drying with the special tool CeboSign to get the stripes horizontal or vertical. The product is still wet do a slight smoothing of the scratches, using a spatula Caress in the sense of processing chosen. Proceed in the preparation and subsequent processing to bands of approximately 1 m. To complete drying of the CeboIdea sand slightly the surface to remove any imperfections, always respecting the machining direction. Apply CeboSi Reflections sponge in one hand. Spread the product on the surface following the direction (horizontal or vertical) of the production realized.